>

安卓版积分斗地主

Call US On:+86-15258318629   Email:info@gxyg682.cn

Eason elevator parts Co.,Ltd.

  • Products
  • About Us
  • FAQ
  • News
  • Contact Us
  • Feedback
  • News Show

    Shopping mall escalator safety cleaning procedures


    2017-3-13 14:17:36
    Cleaning range, including the landing area, ladder, handrails and 
     
    cleaning the cleaning of the two sides of the cleaning plate cleaning 
     
    the daily cleaning time, and the daily tour cleaning, the number of 
     
    daily cleaning can be based on the size of the flow and specific 
     
    standards Request. Cleaning steps to prepare - cleaning garbage - wiping 
     
    handrails and both sides of the guard, dragging the landing area and a 
     
    ladder of a check, finishing. Cleaning methods Automatic ladder cleaning 
     
    work should be arranged in the small flow of noon or before the evening, 
     
    the operating procedures and methods are as follows:
    1, ready to work
     ① Prepare the necessary tools and utensils. Such as broom, mop, rag, 
     
    dry towel, bucket and the corresponding cleaning agent. ② notify the 
     
    elevator to close the automatic ladder, cut off the power. Place the 
     
    "clean" sign on the upper and lower landing areas.
    2, cleaning the garbage from the landing area to the next step to the 
     
    landing area with a broom to clean the garbage.
    3, wiping the handrail and the two sides of the guard will be divided 
     
    into a number of sections (about 2m each), the glass, stainless steel 
     
    and leather products such as spraying a little cleaning agent, and then 
     
    followed by wet wipes wipe , After the water and then wipe with a wet 
     
    cloth, and finally wipe the water with a dry towel.
    4, drag the landing area, step ladder first landing area and stairs are 
     
    divided into several sections (each about 4m), the mop will have been 
     
    prepared into a good detergent bucket, picked up and wring dry, forced 
     
    to drag the landing area , Step ladder, and then immersed in another 
     
    bucket of water, picked up and then wring dry, repeated towing landing 
     
    area, step ladder. Pay attention to the mop to the water is not dripping 
     
    water is appropriate to prevent water infiltration into the trunk, 
     
    causing the motor damp and mechanical damage.
    safety regulations 
    1. Make sure that the elevator is stopped for a large area of cleaning
    2, to ensure that each elevator is clearly aware of the switch position 
     
    and emergency stop button.
    3. Stand in a safe place for cleaning.
     4. If you need to clean the elevator when running, you can not use the 
     
    mop, can only use the broom, so as not to be the edge of the runway, 
     
    comb plate, etc. to catch or drag the tool.
     5. Hand-held elevator comb plate, rungs, aprons are "high-risk zone", 
     
    the gap between them easy to catch small objects. Therefore, in the hand 
     
    lift when standing, do not step on the yellow security warning line, and 
     
    the two cascade connected to the site, otherwise it will be due to the 
     
    height of the steps before and after the fall. And before entering the 
     
    escalator, to tie the shoelaces;
    6. Make sure that the cleaning staff are well coordinated with the 
     
    engineering staff before cleaning to prevent other personnel from 
     
    opening the elevator during the cleaning process.
    7, can not see the elevator outage that can lift the elevator, and some 
     
    relevant elevator elevator personnel to confirm the elevator in the 
     
    outage state.
    8. Clean the elevator when the tools can not use small parts, so as not 
     
    to fall.


    Next:Elevator accessories in the sa

    Previous:How to choose the elevator acc

    Link: